Sparky creates his own B.U.G. using Tony's as a master Reference
|
Made some more progress, I'm still working on the project:
|
|
Tony's Back Up Generator
|
|
|
|
|
|
|
I couldn't find the button he had on top, looks like the spark arrestor off an internal
combustion engine driven generator. Also I had to trim the gribbly on the left, its the mounting side of a
tank spot light. Well I trimmed the radiator that goes on the right too, but only to
knock off a bit of a lip, that turned out to take it down more than Tony's and fit the
continuer a bit. These trimmings are needed to make it all fit width wise on a
'rail' in the MBGD Wall.
|
|
I found this little box looks good for a fuse or switch box, it'll get conduit later.
|
|
|
So I found used a piece from the FMMF that fit nicely into the same place tony had the
spark arrestor. . .accept there's keyhole in it that's just filled with resin from the
tear the mold made there. So I dug up the front and back sensor of some Crush Joe
kit, glued them together, cleaned it up and put it in place, look my BUG is a mouseketer!
|
|
Well this ear thing won't clear the MBGDW niche anyways so I went hunting for the spark
arrestor again. . .it was in the VED sheet, I have one master and 2 copies in my
stash. . .here's one in place, I added another little gribbly to see how it looks.
|
|
